Solution
BCA assessment
The design assessed against the BCA/NCC, clause by clause.
Only a fraction of the BCA/NCC touches any one sheet, and working out which fraction is the job. A senior reads the set, holds the applicable provisions in their head, marks up what fails, and starts again when the next issue lands. The read is expensive, it sits inside a fixed fee, and the sheets at the end of it get less attention than the ones at the start.
CIM assesses the set against the provisions that apply to the building's class and construction type. The BCA/NCC volumes from 2019 to 2025 and the Red Book are preloaded, so the team can query them directly against the job. Each finding cites the clause, the sheet and the revision it was assessed against, so the reviewer is checking a conclusion rather than hunting for the evidence behind it.
Every sheet is assessed to the same standard, and the assessment re-runs on the next issue in minutes. The senior's time goes to the findings that need judgement, and the report that goes out carries a record of what was read.
What comes back
Clause by clause, with the measurement drawn on the sheet it was taken from.
| Clause | Requirement | Result |
|---|---|---|
| C3.4 | Fire doors to exit passageway, -/60/30 | Complies |
| D1.4 | Travel distance to a required exit, 40 m max | 40.605 m · A-2104 |
| D2.13 | Stair treads and risers within permitted range | Complies |
| E1.3 | Hydrant coverage to all parts of the floor | Not demonstrated |
| F2.4 | Sanitary compartment clearances, AS 1428.1 | Designer statement |
D1.4 allows 40 m to a required exit. The path is drawn on the sheet it was measured from.
What it does for your team
Certifiers and surveyors
Your report, populated from the assessment
Clause-by-clause output written into your own report template, with compliance statuses your practitioners recognise.
Consultants
Targeted checks, cited and checkable
A specific question against a specific clause, with the sheet and the measurement shown, so a reviewer confirms it in seconds.
Builders
Code risk found before it is built
A clause the design misses costs rework at your cost. The assessment runs on each issue as the set develops.
Before CIM
- Senior hours spent locating the provisions that apply before any assessment starts.
- The last sheets in a set get a thinner read than the first.
- Each reissue means starting the code read again.
With CIM
- The whole set assessed against the provisions that apply to the job.
- Every finding cited to the clause, the sheet and the revision.
- The assessment re-runs on each issue, to the same standard.